Hi Bulltear folks,
Does anyone have a good source for this? I found one option here: http://www.innomach.com/images/2012-IMS-CATALOG.pdf
at $35/per head, but don't know anything about the shop. Does anyone here have a recommendation?
The machine shop was able to machine the head to get 8.5:1 compression and he said if we can get a thinner head gasket, we can maximize quench to get 9:1 compression. Will be running a k8600 on a full engine rebuild. Only keeping the stock pistons with an engine hone and new rings. Crank was turned 10-10. All new clevite bearings. Will be running performer manifold with an edelbrock 600.
Thanks!
Shawn